LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Starter Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: View Of Starter Bolts & Starter
    GM1861149Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the starter and bolts.

    Tighten:  Tighten the bolts to 50 N.m (37 lb ft).

    2. Fig 2: Identifying Engine Wiring Harness Electrical Connector
    GM1860484Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (1) to the starter.
    3. Fig 3: View Of Battery Positive Junction Block Cable Clip & Cable Terminal
    GM1861148Courtesy of GENERAL MOTORS CORP.
  3. Install the battery positive junction block cable terminal (2) to the starter.
  4. Install the starter solenoid BAT terminal nut (3).

    Tighten:  Tighten the nut to 25 N.m (18 lb ft).

    5. Fig 4: Identifying Starter Heat Shield Bolt & Shield
    GM1861146Courtesy of GENERAL MOTORS CORP.
  5. Install the starter heat shield and bolt.

    Tighten:  Tighten the bolt to 7 N.m (62 lb in).

  6. Install the left catalytic convertor. Refer to Catalytic Converter Replacement - Left Side .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals