Circuit/System Verification
- Verify that no other DTCs are not set.
- If any other DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- Engine idling, observe the appropriate scan tool HO2S voltage parameter. The voltage should fluctuate above and below the range of 350-550 mV.
- Observe the scan tool DTC information. DTCs P0133 and P0153 should not set.
- Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.