Component Testing
- Seal the EVAP system using the EVAP Purge/Seal function with a scan tool.
- Pressurize the EVAP system to 9.33 mm/Hg (5 in/H2O).
- Compare the scan tool Fuel Tank Pressure sensor parameter to the J 41413-200
pressure/vacuum gage. See Special Tools
. Verify the scan tool FTP sensor parameter is within 1.86 mm/Hg (1 in/H2O) of the pressure/vacuum gage.
- If not within the specified range, replace the FTP sensor.
- Command the EVAP vent valve open with a scan tool. Verify the scan tool Fuel Tank Pressure parameter is at 0 mm/Hg (0 in/H2O).
- If not within the specified range, replace the FTP sensor.