Circuit/System Testing
- Disconnect the EVAP purge solenoid valve electrical harness connector.
- Start the engine.
- Command the EVAP vent closed with a scan tool.
- Increase the engine speed to 1, 200-1, 500 RPM.
- Observe the scan tool fuel tank pressure (FTP) sensor parameter. Verify the scan tool FTP sensor parameter is -0.9 to +0.9 mm Hg (-0.5 to +0.5 in. H2O).
- If not within the specified range, replace the EVAP purge solenoid valve.
- Ignition ON, engine OFF, disconnect the EVAP purge solenoid valve pipe.
- Observe the scan tool FTP sensor parameter. Verify the FTP sensor parameter is -0.9 to +0.9 mm Hg (-0.5 to +0.5 in. H2O).
- If not within the specified range, replace the FTP sensor.