Removal Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Fuel Level Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Remove the fuel tank module. Refer to Fuel Tank Module Replacement .
Push down on the fuel level sensor electrical connector tab (1), disengaging the retainer, and disconnect the electrical connector.

Fig 2: View Of Module Clip

Courtesy of GENERAL MOTORS CORP.

Remove the fuel level sensor wiring from under the module clip (2).
Push in the fuel level sensor tabs (1) disengaging the sensor clips from the module bucket.

Fig 3: Identifying Fuel Module Bucket

Courtesy of GENERAL MOTORS CORP.

Slide the fuel level sensor up out from the module bucket.