Removal Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Front & Rear Brake Pipes

Courtesy of GENERAL MOTORS CORP.

Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement .
Release the front and rear brake pipes (1) from the routing clip on the frame rail.
Remove the 2 brake pressure modulator valve (BPMV) bracket nuts (2).

Fig 2: View Of BPMV Insulator Nuts & Washers

Courtesy of GENERAL MOTORS CORP.

NOTE: Carefully separate the BPMV from the bracket. Do not pry on the accumulator covers on the underside of the BPMV.

Remove the 2 BPMV nuts and washers.

Fig 3: Identifying BPMV Insulators

Courtesy of GENERAL MOTORS CORP.

Carefully lift the BPMV assembly upward to release the BPMV from the bracket.
Remove the BPMV bracket.
Remove the 2 upper BPMV bracket insulators.
Inspect the bracket insulators for damage and replace, if necessary.
Remove the lower BPMV bracket insulator.
Inspect the bracket insulator for damage and replace, if necessary.