LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 51 (Antilock Brake System With Traction Control System & Stability Control System) >> Repair Instructions >> Rear Wheel Speed Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wheel Speed Sensor Bolt
    GM1861969Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel speed sensor to the wheel knuckle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the wheel speed sensor bolt.

    Tighten:  Tighten the bolt to 9 N.m (80 lb in).

    3. Fig 2: View Of Wheel Speed Sensor Wire Harness Routing Clip
    GM1861966Courtesy of GENERAL MOTORS CORP.
  3. Install the wheel speed sensor wire harness routing clips to the upper suspension link.
    4. Fig 3: Identifying Wheel Speed Sensor Electrical Connector
    GM1861964Courtesy of GENERAL MOTORS CORP.
  4. Install the wheel speed sensor wire harness routing clips (3) to the upper suspension link.
  5. Install the wheel speed sensor wire harness grommet (2) to the lower control arm bracket.
  6. Connect the wheel speed sensor electrical connector (1).
  7. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  8. Perform the Diagnostic System Check - Vehicle .
scientia non olet · About LEMON Manuals