Circuit/System Verification
- Ignition ON, observe the scan tool Tilt Up Switch and Tilt Down Switch parameters while cycling the tilt/telescope switch between the TILT UP and TILT DOWN positions. The parameters should cycle between Active and Inactive.
- If the parameters do not cycle between the specified values, refer to Steering Column Tilt/Telescoping Inoperative
- Observe the scan tool Tilt Sensor parameter. The reading should be between 0.2 and 4.8 volts.
- If not within the specified range, refer to Tilt Sensor Circuit Malfunction .
- Command the column to tilt up and down using the tilt/telescope switch. The column should move up and down.
- If the column does not operate as specified, refer to Tilt Actuator Circuit Malfunction .