LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LS, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Lighting System) >> Diagnostic Information and Procedures >> DTC C0297 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the TCM and the X1 harness connector at the ECM.
  2. Connect a test lamp between the TCM signal circuit terminal 16 and ground.
  3. Ignition ON, press and release the brake pedal. The test lamp should turn ON and OFF when pressing and releasing the brake pedal.
    • If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit test normal, replace the BCM.
    • If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the BCM.
  4. Ignition OFF, connect the harness connector at the TCM.
  5. Connect a test lamp between the ECM signal circuit terminal 7 and ground.
  6. Ignition ON, press and release the brake pedal. The test lamp should turn ON and OFF when pressing and releasing the brake pedal.
    • If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuit test normal, replace the TCM.
  7. If all circuit tests normal, replace the ECM.
scientia non olet · About LEMON Manuals