LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 33 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Lower Control Arm
    GM1853091Courtesy of GENERAL MOTORS CORP.
  1. Position the front lower control arm in the frame.
    2. Fig 2: Identifying Control Arm Mounting Bolt And Nut
    GM1853070Courtesy of GENERAL MOTORS CORP.
  2. Install the front lower control arm rear nut (2) and bolt (1). Hand tighten the rear nut (2).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the front lower control arm front nut (4) to the stud (3) and tighten to 195 N.m (144 lb ft).
    4. NOTE: Use the appropriate size wrench to hold the bolt while torquing the nut.
  4. Tighten the front rear lower control arm rear nut (2) to 150 N.m (111 lb ft).
    5. Fig 3: Identifying Ball Joint Mounting Nut
    GM1853193Courtesy of GENERAL MOTORS CORP.
  5. Connect the lower ball joint in the knuckle.
  6. Install the ball joint nut and tighten to 40 N.m (30 lb ft).
  7. Tighten the ball joint nut an additional 90 degrees.
  8. Connect the outer tie rod end. Refer to Steering Linkage Outer Tie Rod Replacement .
  9. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  10. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals