LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2009 >> Traverse LT, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Sunroof System) >> Repair Instructions >> Sunroof Track Timing/Synchronization >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Saturn Outlook, 2010 GMC Acadia, 2010 Chevrolet Traverse, and 2010 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Refer to Fastener Caution .
  1. Install the sunroof window. Refer to Sunroof Window Replacement .

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

  2. Install the motor/actuator. Refer to Sunroof Motor/Actuator Replacement .

    Tighten:  Tighten the motor attachment screws to 3.5 N.m (31 lb in).

  3. Connect the electrical connector to the motor/actuator.
    4. Fig 1: View Of Pin & Drive Motor
    GM1549380Courtesy of GENERAL MOTORS CORP.
  4. Remove the pin (1) from the holes that held the position while installing the drive motor.
  5. Install the headliner. Refer to Headlining Trim Panel Replacement .
  6. Perform the Initialization/Teach Procedure. Refer to Sunroof Motor/Actuator Initialization/Teach Process (New Motor)  or Sunroof Motor/Actuator Initialization/Teach Process (New Roller Sunshade)  or Sunroof Motor/Actuator Initialization/Teach Process (Existing Motor)  or Sunroof Motor/Actuator Initialization/Teach Process (Existing Roller Sunshade) .
  7. Verify the operation of the sunroof.
scientia non olet · About LEMON Manuals