LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2010 >> Malibu LS, 3.5 N >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.5L - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: Disconnecting/Connecting Camshaft Position (CMP) Sensor Electrical Connector
    GM1599076Courtesy of GENERAL MOTORS CORP.
  1. Replace the O-ring seal if damaged, lubricate the NEW O-ring with clean engine oil.
  2. Install the CMP sensor.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 10 N.m (89 lb in).

    4. Fig 2: View Of Fuel Injector Wiring Harness Electrical Connector
    GM1775160Courtesy of GENERAL MOTORS CORP.
  4. Connect the fuel injector wiring harness electrical connector to the CMP sensor.
  5. Install the power steering pump, if required. Refer to Power Steering Pump Replacement (LZ4) .
  6. Install the intake manifold cover. if required. Refer to Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals