Circuit/System Verification
- Ignition ON and fuel cap removed, verify that the FTP sensor parameter is between 1.3-1.7 V.
- If not within the specified range, go to the FTP sensor section in Circuit/System Testing below.
- Install the fuel cap.
- With the engine running, the EVAP canister vent solenoid valve open and the EVAP canister purge solenoid valve commanded to 100 %, the fuel tank vacuum should not increase to more than -15 mm Hg (-8 in. H2O).
- If the fuel tank vacuum is greater than the specified range, go to the restriction section in Circuit/System Testing.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.