Installation Procedure

WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of APP Sensor Bolts & Sensor

Courtesy of GENERAL MOTORS CORP.

Install the upper bolt into the APP sensor assembly.
Install the APP sensor assembly into the vehicle.

CAUTION: Refer to Fastener Caution .

Install the remaining 2 lower APP sensor assembly bolts.
Tighten: Tighten the bolts to 8 N.m (71 lb in).

Fig 2: Identifying Accelerator Pedal Position Sensor Assembly

Courtesy of GENERAL MOTORS CORP.

Install the I/P wiring harness electrical connector (2) to the APP sensor assembly.
Install the driver knee bolster. Refer to Driver Knee Bolster Replacement (Traverse) or Driver Knee Bolster Replacement (Acadia) or Driver Knee Bolster Replacement (Enclave) or Driver Knee Bolster Replacement (OUTLOOK) .
Install the left I/P insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side (Acadia) or Instrument Panel Insulator Panel Replacement - Left Side (Enclave) or Instrument Panel Insulator Panel Replacement - Left Side (OUTLOOK) or Instrument Panel Insulator Panel Replacement - Left Side (Traverse) .