LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2010 >> Traverse LS, FWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - DTC P0192 To DTC P0629/P062B >> DTC P0442 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

NOTE:
  • Refer to the J 41413-200:  EEST operation manual for detailed instructions in Evaporative Emission System Diagnosis .
  • Larger volume fuel tanks and/or those with lower fuel levels may require several minutes for the floating indicator to stabilize.
  • Ensure that the underbody temperature of the vehicle and the tester are similar.
  1. Disconnect the purge tube at the quick connector on the evaporative emission canister side of the Q12 evaporative emission canister purge solenoid valve and install the CH 48096:  Port Tool.
  2. Connect the J 41413-200:  EEST to the CH 48096:  Port Tool.
  3. Using a scan tool close the evaporative emission canister vent solenoid valve to seal the evaporative emission system.
  4. Use the flow meter on the J 41413-200:  EEST, calibrated to 0.51 mm (0.020 in) to determine that there is no leak in the evaporative emission system.
    • If a leak is detected, use the J 41413-200:  EEST to apply smoke to the evaporative emission system at the purge tube until the leak is located using the J 41413-SPT:  White Light.
scientia non olet · About LEMON Manuals