LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2010 >> Traverse LTZ, AWD >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Control System & Fuel System - 3.6L - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake >> Installation Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Installation Procedure

    Fig 1: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the CMP sensor (2) and bolt. Tighten the bolt to 10 N.m (89 lb in).
    2. Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860428Courtesy of GENERAL MOTORS CORP.
  2. Connect the engine wiring harness electrical connector (1) to the bank 1 intake CMP sensor (2).
scientia non olet · About LEMON Manuals