LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Camaro SS, 2D Convertible, 6.2 W >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.2L - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

    Fig 1: Identifying CMP Sensor & Retaining Bolt
    GM1950759Courtesy of GENERAL MOTORS CORP.
    NOTE: Install a NEW O-ring to the camshaft sensor
    NOTE: Before installing the camshaft sensor, apply a small amount of clean motor oil to the O-ring (3).
  1. Install a NEW O-ring (3) to the CMP sensor.
  2. Install the CMP sensor (2) to the engine front cover.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the CMP sensor to engine front cover retaining bolt (1) and tighten to 9 N.m (80 lb in).
    4. Fig 2: Identifying Camshaft Position (CMP) Sensor & Electrical Connector
    GM1950789Courtesy of GENERAL MOTORS CORP.
  4. Connect the CMP sensor electrical connector (1) to wiring harness.
  5. Install the engine cover. Refer to Engine Cover Replacement .
  6. Connect the battery ground cable to the battery. Refer to Battery Negative Cable Disconnection and Connection .
  7. If re-programming is required, refer to Control Module References .
scientia non olet · About LEMON Manuals