Instrument Cluster Replacement and/or Reprogramming

If the instrument cluster needs to be replaced and/or reprogrammed, the following procedures must be performed:

1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) .
NOTE:

The Prepare Control Module for Removal function can only be performed when communication with the old control module is still possible.

2. Before removing the old instrument cluster, perform the SPS function Prepare Control Module for Removal.
3. Replace the instrument cluster.
4. Perform the SPS function Instrument Cluster - Programming and follow the on-screen instructions.
5. Perform the SPS function Instrument Cluster - Configuration and follow the on-screen instructions.
6. Perform the SPS function Instrument Cluster - Setup and follow the on-screen instructions.
7. Clear DTCs after completing the programming procedure.