LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Cruze LS, Automatic >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Programming And Setup - All Systems >> Repair Instructions >> Instrument Cluster Programming and Setup >> Instrument Panel Cluster Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Instrument Panel Cluster Programming

To program and setup an existing or new replacement instrument panel cluster, perform the following procedure:

  1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) 
  2. On the SPS Supported Controllers screen, select IPC Instrument Cluster - Programming and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select IPC Instrument Cluster - Configuration and follow the on-screen instructions.
  4. On the SPS Supported Controllers screen, select IPC Instrument Cluster - Setup and follow the on-screen instructions.

If the instrument panel cluster fails to accept the program, verify all scan tool and instrument panel cluster connections are secure.

NOTE: After programming is completed, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. With a scan tool, clear all DTC's from all modules.
scientia non olet · About LEMON Manuals