Installation Procedure
- Inspect each spark plug gap. Adjust each plug as needed. Refer to Ignition System Specifications .
- Hand start the spark plugs in the corresponding cylinders.
- Tighten the spark plugs for used heads to 15 N.m (11 lb ft). Tighten the spark plugs for new aluminum heads to 20 N.m (15 lb ft). Tighten the spark plugs for new iron heads to 30 N.m (22 lb ft).
- Install the spark plug wires. Refer to Spark Plug Wire Replacement .
NOTE:
The spark plug comes pre-gapped. Do not change the spark plug gap from 1.01 mm (0.040 in).
CAUTION:
Refer to Fastener Caution .