LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Cutaway 6.6 L >> Repair and Diagnosis (Single Page) >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Electronic Brake Control Module Replacement >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

Fig 1: EBCM & BPMV
GM2001464Courtesy of GENERAL MOTORS CORP.
  1. Carefully align and install the EBCM (1) to the BPMV.

    Do not force the components together.

    CAUTION: Refer to Fastener Caution .
    2. Fig 2: EBCM Bolts
    GM2001462Courtesy of GENERAL MOTORS CORP.
  2. Install new EBCM bolts (1).

    Tighten the bolts in a cross pattern to 3 N.m (27 lb in).

  3. Connect the electrical connector to the EBCM.
  4. Install the brake modulator shield and the mounting nuts, if equipped, and tighten to 25 N.m (18 lb ft).
  5. Install the brake modulator shield mounting bolt and tighten to 25 N.m (18 lb ft).
  6. Lower the vehicle.
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  8. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals