LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Impala LT >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.5L - DTC P0010 Through DTC P0340 >> DTC P0335 >> Component Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Component Testing

NOTE: You must perform the Circuit/System Testing before proceeding with Component Testing.
  1. Inspect the B26 crankshaft position sensor for looseness and correct installation. Remove the crankshaft position sensor from the engine and inspect the sensor and the O-ring for damage.
    • If the sensor is loose, incorrectly installed, or damaged, repair or replace the B26 crankshaft position sensor.
  2. Connect the crankshaft position sensor connector to the crankshaft position sensor. Turn ON the ignition, with the engine OFF.
  3. Observe the Crankshaft Position Active Counter parameter with a scan tool. Pass a flat steel object by the tip of the sensor repeatedly. The crankshaft position active counter parameter should increment.
    • If the function does not perform as specified, replace the B26 crankshaft position sensor.
scientia non olet · About LEMON Manuals