Adding Keys (Without SPS)

NOTE:

To initiate, this procedure requires that 1 learned key be available.
A total of 8 keys maybe be learned to a single vehicle.
This procedure adds keys only. The procedure does not erase previously learned keys.
The keys to be learned must duplicate the mechanical cut of the current key.

Place the recognized key(s) in the vehicle cupholder.
Insert the mechanical key of the new transmitter into the key lock cylinder located on the outside of the driver door and turn the key to the unlock position five times within ten seconds. The Driver Information Center (DIC) will display Ready For Remote #2, 3, 4 or 5.

NOTE: The transmitter slot is located inside the upper instrument panel storage compartment. The rubber mat lining the bottom of the compartment needs to be removed to access the slot.

Remove the rubber mat in the instrument panel storage compartment. Extend the key blade on the new transmitter and insert the key into the transmitter slot.
Press and hold the vehicle ignition mode switch for two seconds. When the transmitter is programmed, the DIC will show that it is ready to program the next transmitter.
Remove the key from the slot and press the unlock button. To program additional transmitters, repeat Steps 3 through 5.
When all additional transmitters are programmed, press and hold the ignition mode switch for 10 seconds to exit programming mode.