LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2011 >> Volt >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.4L (LUU) - DTC P0010 Through DTC P0328 >> DTC P0128 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the B34 engine coolant temperature sensor.
  2. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down.Test for less than 5 Ω between the low reference circuit terminal 2 and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20 engine control module.
  3. Service Mode active, verify the scan tool ECT Sensor parameter is colder than -39°C (-38°F).
    • If warmer than the specified range, test the signal circuit terminal 2 for a short to ground. If the circuit tests normal, replace the K20 engine control module.
    4. NOTE: If the fuse in the jumper wire opens, the signal circuit is shorted to a voltage and the sensor may be damaged.
  4. Install a 3 A fused jumper wire between the signal circuit terminal 2 and the low reference circuit terminal 1. Verify the scan tool ECT Sensor parameter is greater than 130°C (266°F).
    • If less than the specified range, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the K20 engine control module.
  5. If all circuits test normal, test or replace the B34 engine coolant temperature sensor.
scientia non olet · About LEMON Manuals