Installation Procedure
WARNING: This page is about a different car, the 2012 Chevrolet Volt. However, it is still accessible from the selected car via links, so may be relevant.
- Align the locating pin on the brake control brake pedal position sensor (1) to the hole on the brake pedal assembly bracket.
- Ensure the brake control brake pedal position sensor fork is properly located on the brake pedal pin.
- Install the brake control brake pedal position sensor bolt (1) and tighten to 9 N.m (80 lb in).
- Connect the brake control brake pedal position sensor electrical connector.
- Perform the Diagnostic System Check - Vehicle .
CAUTION:
Refer to Fastener Caution .