Common Specs & Procedures Index
VOLT COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | REFRIGERANT SYSTEM SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Axle Nut/Hub Nut (Front) | |||
| First Pass | 111 Ft. Lb. (150 N.m) | ||
| Final Pass | Loosen 45 degrees | ||
| Battery | BATTERY USAGE | ||
| Brakes | |||
| Bleeding Sequence | RR, LR, RF, LF HYDRAULIC BRAKE SYSTEM BLEEDING (MANUAL) |
||
| Disc Brakes | |||
| Service Specifications | DISC BRAKE COMPONENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Charging | |||
| Generator | SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Drive Belts | |||
| Adjustment | Serpentine belt used, not adjustable. | ||
| Drive Belt Routing | Se appropriate graphic under WATER PUMP BELT REPLACEMENT . | ||
| Engine Cooling | |||
| General Service Specifications | ENGINE COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | Pressure stamped on cap. | ||
| Thermostat R & I | |||
| 1.4L | ENGINE COOLANT THERMOSTAT REPLACEMENT | ||
| Water Pump R & I | |||
| 1.4L | WATER PUMP REPLACEMENT | ||
| Engine Mechanical | |||
| 1.4L | |||
| Compression | ENGINE COMPRESSION TEST | ||
| Oil Pressure (At idle speed.) | 22 psi (150 kPa) | ||
| Overhaul | ENGINE MECHANICAL SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque | 46 Ft. Lbs. (62 N.m) | ||
| Fuel System | |||
| Pressure Specification | 53-60 psi (365-414 kPa) | ||
| Fuel Pressure Test Procedure | FUEL SYSTEM DIAGNOSIS | ||
| Fuel Filter Location | Fuel filter is an integral part of fuel tank pump module. | ||
| Fuel Filter R & I | FUEL TANK FUEL PUMP MODULE REPLACEMENT | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | Engine has coil module-on-plug ignition. | ||
| Ignition Wires (Routing) | Engine has coil module-on-plug ignition. | ||
| Spark Plug | |||
| 1.4L (Type: GM 55564962) | |||
| Gap | Gap pre-set by manufacturer. Not adjustable. | ||
| Torque | 18 Ft. Lb. (25 N.m) | ||
| Starting | |||
| Starter HQ1 hybrid system does not use a conventional starter. |
Refer to Hybrid Modes of Operation Description for information about the starting system. | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque | FASTENER TIGHTENING SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 100 Ft. Lb. (140 N.m) See Wheel Nut Tightening Sequence illustration under INSTALLATION PROCEDURE | ||