LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Repair Instructions >> Front Wheel Speed Sensor Replacement >> Removal Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal Procedure

WARNING:

Refer to Brake Dust Warning .

    Fig 1: Front Wheel Sensor Electrical Connector
    GM2196949Courtesy of GENERAL MOTORS COMPANY
  1. From inside the engine compartment, disconnect the front wheel sensor electrical connector (1).
  2. Release the wheel speed sensor electrical connector retainer from the inner wheel house panel.
  3. Feed the wheel speed sensor electrical connector and harness through the wheel house panel closeout.
  4. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  5. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (w RT2) , Tire and Wheel Removal and Installation (w/o RT2) .
    6. Fig 2: Wheel Speed Sensor Wire Harness
    GM2196950Courtesy of GENERAL MOTORS COMPANY
  6. Release the wheel speed sensor wire harness retainer (1) from the outer wheel house panel.
  7. Release the wheel speed sensor wire harness from the front suspension strut (2).
    8. Fig 3: Wheel Speed Sensor & Bolt
    GM2196952Courtesy of GENERAL MOTORS COMPANY
  8. Clean the wheel speed sensor area on the steering knuckle of any accumulated dirt and debris.
  9. Remove the wheel speed sensor bolt (1).
  10. Remove the wheel speed sensor assembly from the steering knuckle by pulling straight out.
scientia non olet · About LEMON Manuals