Windshield Wiper System Module Replacement

WARNING: This page is about a different car, the 2011 Chevrolet Caprice. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Windshield Wiper System Module

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedure Remove the lower air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Lower Panel) , Air Inlet Grille Panel Replacement (Upper Panel) .
1	Windshield Wiper System Module Bolt (Qty: 2) CAUTION: Refer to Fastener Caution . Tighten 8 N.m (71 lb in)
2	Windshield Wiper System Module Procedure Lift the module assembly slightly and pull inward toward the center of the vehicle in order to release the alignment pilot from the fender flange. Disconnect the electrical connector from the wiper motor. Lift the wiper module assembly from the plenum and remove from the vehicle. TIP: Insert the alignment pilot into the fender flange prior to installing and securing the wiper module bolts.

Callout

Component Name

Preliminary Procedure
Remove the lower air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Lower Panel) , Air Inlet Grille Panel Replacement (Upper Panel) .

Windshield Wiper System Module Bolt (Qty: 2)

CAUTION:

Refer to Fastener Caution .

Tighten
8 N.m (71 lb in)

Windshield Wiper System Module

Procedure

Lift the module assembly slightly and pull inward toward the center of the vehicle in order to release the alignment pilot from the fender flange.
Disconnect the electrical connector from the wiper motor.
Lift the wiper module assembly from the plenum and remove from the vehicle.
TIP: Insert the alignment pilot into the fender flange prior to installing and securing the wiper module bolts.