Installation Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Caprice. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Front Impact Sensor Electrical Connections

Courtesy of GENERAL MOTORS CORP.

Install the front impact sensor electrical connections (1).

NOTE:

Locating lugs will hold the NEW sensors in place.

Install the NEW front impact sensors (2) to the front end module (3).

Fig 2: Identifying Right Front Impact Sensor To Front End Module Retaining Bolt

Courtesy of GENERAL MOTORS CORP.

CAUTION:

Refer to Fastener Caution .

Install the right front impact sensor to front end module retaining bolt (1) and tighten to 9 N.m (80 lb in).

Fig 3: Identifying Left Front Impact Sensor To Front End Module Retaining Bolt

Courtesy of GENERAL MOTORS CORP.

NOTE:

The radiator top mounts can be taken off and the radiator lent back to aid in installation.

Install the left front impact sensor to front end module retaining bolt (1) and tighten to 9 N.m (80 lb in).
Enable the SIR. Refer to SIR Disabling and Enabling .