Inflatable Restraint Sensing & Diagnostic Module Programming & Setup
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2013 GMC Savana, 2013 GMC RV Cutaway, 2013 GMC Cutaway, 2013 Chevrolet RV Cutaway, and 2013 Chevrolet Express. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The air bag indicator light may remain ON after the body control module (BCM), or inflatable restraint sensing and diagnostic module (SDM) is replaced, and during the programming procedure for the BCM until after the procedure is completed. When installing a new SDM, there may be several DTCs set prior to programming. Once programmed, these DTCs should be in history and can be cleared. If both the rollover sensor and the SDM are replaced at the same time, perform Airbag Vehicle Rollover Sensor Programming and Setup first.
- If DTC B0090 is set, refer to DTC B0090 .
- Ignition ON, program the SDM. Refer to Service Programming System (SPS) .
- In the BCM Module Setup menu, select Setup SDM Primary Key in BCM. Follow the scan tool on screen instructions.
- In the SDM Module Setup menu, select Setup SDM. Follow the scan tool on screen instructions.
- Cycle the ignition from OFF to ON. Verify no DTCs are set. If any DTCs are set, refer to Diagnostic Trouble Code (DTC) List - Vehicle .