Reprogram Control Module
WARNING: This page is about a different car, the 2014 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
To reprogram an existing ECM, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Engine Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Engine Control Module - Setup and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Engine Control Module - Configuration and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Engine Function - Learn/Setup and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
- With a scan tool, reset the Engine Oil Life Remaining back to the original percentage recorded before the control module was replaced, if available.