LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> ATEQ TPMS Reset Procedure >> ATEQ TPMS Reset Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

ATEQ TPMS Reset Procedure

NOTE: Unless otherwise stated, on most tire pressure sensor equipped vehicles, low tire pressure indicator lights and messages can be cleared by inflating tires to the specified pressure and driving at least 25 mph or more for a few minutes. A sensor activation tool (TPMS3) can be used in place of driving.
  1. Set the tire pressure of all wheels to pressure specified on the tire and loading information label.
  2. Turn ignition ON with engine OFF. Apply parking brake.
  3. Using driver information center buttons, initiate the Tire Pressure Sensors Learn mode. A double horn chirp will sound indicating the Learn mode has been enabled. The left front turn signal will also be illuminated.
  4. Starting with left front tire, hold the TPMS3 against the side wall of the tire, within 3 inches of the valve stem. Press TEST button on the TPMS3 until a horn chirp sounds.
  5. After horn chirp has sounded, proceed to the next 3 sensors in the following order: right front, right rear and left rear.
  6. After left rear sensor has been learned, turn ignition switch to OFF position to exit Learn Mode.
scientia non olet · About LEMON Manuals