LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 62 (Object Detection System) >> Diagnostic Information and Procedures >> DTC B1405 >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at each of the object sensors.
  2. Start at the B78G rear object sensor-left outer, ignition ON, activate the park assist, test for 6.3-10.4 V between the 8 V reference circuit terminal 1 at the object sensor harness connector and ground.
    • If less than the specified range, test the 8 V reference circuit for a short to ground. If the circuit tests normal, replace the K41 parking assist control module.
    • If greater than the specified range, test the 8 V reference circuit for a short to voltage. If the circuit tests normal, replace the K41 parking assist control module.
  3. Install each object alarm sensor harness connector one at a time, checking DTCs after each sensor is connected. Verify DTC B1405 is not set as current.
    • If the DTC is set, replace the object alarm sensor that was connected immediately before the DTC set.
    4. NOTE: Make sure to check front object sensors.
  4. If all circuits test normal, replace the K41 parking assist control module.
scientia non olet · About LEMON Manuals