Component Testing
- Disconnect the harness connector at the steering wheel controls switch-left.
- Cruise control switch ON, measure the resistance between terminal 1 and terminal 3 while individually activating and holding each cruise control function switch and compare the resistance reading to the values in the table below.
- If not within the specified resistance range, replace the steering wheel controls switch-left.
| Function Switch | Minimum Resistance Value | Maximum Resistance Value |
|---|---|---|
| Off | O.L. | O.L. |
| On | 6.5k Ohms | 7.1k Ohms |
| - SET | 2.2k Ohms | 2.4k Ohms |
| + RES | 3.7k Ohms | 3.9k Ohms |
| Cancel | 1.4k Ohms | 1.6k Ohms |