Radio Replacement

Fig 1: Identifying Radio

Courtesy of GENERAL MOTORS COMPANY

Radio Replacement

Callout	Component Name
Preliminary Procedure Remove the instrument panel accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement (Acadia) , Instrument Panel Accessory Trim Plate Replacement (Enclave) , Instrument Panel Accessory Trim Plate Replacement (Traverse) .
1	Radio Screw (Qty: 4) CAUTION: Refer to Component Fastener Tightening Caution . Tighten 2.5 N.m (22 lb in)
2	Radio Assembly Procedure Disconnect the electrical connector. Disconnect the antenna cable. Reprogram the radio after replacement. Refer to Control Module References . TIP: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.

Callout

Component Name

Radio Screw (Qty: 4)

CAUTION:

Tighten
2.5 N.m (22 lb in)

Radio Assembly

Procedure

TIP: When installing the radio verify that the locator pin on the back of the radio is firmly seated in the I/P structure extension.