LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Battery, Charging System And Starting System) >> Repair Instructions >> Generator Replacement (LF1) >> Installation Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Idler Pulley Bolt & Idler Pulley
    GM2196009Courtesy of GENERAL MOTORS CORP.
  1. Position the generator (4) to the engine.
  2. Loosely install the generator bolts (3).
  3. Install the idler pulley. Refer to Drive Belt Idler Pulley Replacement .
    4. CAUTION: Refer to Fastener Caution .
  4. Tighten the generator bolts in the sequence shown to 50 N.m (37 lb ft).
    5. Fig 2: Identifying Generator Electical Harness Connector & Nut
    GM2196013Courtesy of GENERAL MOTORS CORP.
  5. Install the drive belt. Refer to Drive Belt Replacement .
  6. Connect the engine harness electrical connector to the generator (1).
  7. Install the positive battery cable terminal to the generator.
  8. Install the positive battery cable nut at the generator and tighten to 15 N.m (11 lb ft).
  9. Position the positive battery cable boot at the generator terminal.
  10. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals