LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (Programming And Setup - All Systems) >> Repair Instructions >> Electronic Brake Control Module Programming and Setup >> Electronic Brake Control Module Replacement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronic Brake Control Module Replacement

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.

If the electronic brake control module (EBCM) needs to be replaced, the following procedures must be performed:

  1. Connect a scan tool to the vehicle and access SPS. Refer to Service Programming System (SPS) 
  2. Perform the SPS function Electronic Brake Control Module - Programming and follow the on-screen instructions.
  3. Perform the SPS function Electronic Brake Control Module - Configuration & Setup and follow the on-screen instructions. On the screen Control Module - Configuration and Setup Function(s), select both ECU Configuration/Reconfiguration and ECU Setup.
  4. Clear DTCs after completing the programming procedure
scientia non olet · About LEMON Manuals