Replace and Program Control Module
WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement engine control module (ECM), perform the following procedure:
- Install EL-49642 SPS Programming Support Tool.
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select ECM Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select ECM Control Module - Setup and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select ECM Control Module - Configuration and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select ECM Function - Learn/Setup and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
- With a scan tool, perform the Theft Deterrent Programming. Refer to Immobilizer System Component Programming .
- With a scan tool, perform the Brake Pedal Position Sensor Learn. Refer to Brake Pedal Position Sensor Learn .
- With a scan tool, perform the CKP System Variation Learn. Refer to Crankshaft Position System Variation Learn .
- With a scan tool, perform the Throttle/Idle Learn procedure. Refer to Q38 Throttle Body: Throttle/Idle Learn .
- With a scan tool, reset the Engine Oil Life Remaining back to the original percentage recorded before the control module was replaced, if available.