LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (Cellular Systems, Entertainment Systems & Navigation Systems) >> Diagnostic Information and Procedures >> OnStar Button LED Malfunction >> Circuit/System Testing
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the A10 inside rear view mirror.
  2. Doors closed, courtesy lamps OFF, test for less than 10 Ω between the ground circuit terminal 5 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, command the green LED OFF with a scan tool. Test for less than 1 V between the control circuit terminal 6 and ground.
    • If greater than the specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the K73 telematics communication interface control module.
  4. Command the green LED ON with a scan tool. Test for greater than 9 V between the control circuit terminal 6 and ground.
    • If less than the specified range, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K73 telematics communication interface control module.
  5. Command the red LED OFF with a scan tool. Test for less than 1 V between the control circuit terminal 7 and ground.
    • If greater than the specified range, test the control circuit for a short to voltage. If the circuit tests normal, replace the K73 telematics communication interface control module.
  6. Command the red LED ON with a scan tool. Test for greater than 9 V between the control circuit terminal 7 and ground.
    • If less than the specified range, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K73 telematics communication interface control module.
  7. If all circuits test normal, replace the A10 inside rear view mirror.