Installation Procedure
WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
- Install the wheel speed sensor to the wheel knuckle.
- Install the wheel speed sensor bolt.
Tighten
Tighten the bolt to 9 N.m (80 lb in).
- Install the wheel speed sensor wire harness routing clips to the upper suspension link.
- Install the wheel speed sensor wire harness routing clips (3) to the upper suspension link.
- Install the wheel speed sensor wire harness grommet (2) to the lower control arm bracket.
- Connect the wheel speed sensor electrical connector (1).
- Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
- Perform the Diagnostic System Check - Vehicle .
CAUTION:
Refer to Fastener Caution .