LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Programming And Setup - All Systems) >> Repair Instructions >> Electronic Brake Control Module Programming and Setup >> Electronic Brake Control Module (EBCM) Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronic Brake Control Module (EBCM) Programming

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

To program and setup an existing or new replacement EBCM, perform the following procedure:

  1. With a scan tool, access the Service Programming System (SPS) and follow the on-screen instructions. Refer to Service Programming System (SPS) .
  2. On the SPS Supported Controllers screen, select EBCM Electronic Brake Control Module - Programming and follow the on-screen instructions.
  3. On the SPS Supported Controllers screen, select EBCM Electronic Brake Control Module - Setup and follow the on-screen instructions.

If the EBCM fails to accept the program, verify all scan tool and EBCM connections are secure.

NOTE: After programming is completed, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF for 10 seconds.
  2. Open and close the door.
  3. Connect the scan tool to the data link connector.
  4. Ignition ON, engine OFF.
  5. With a scan tool, clear all DTC's from all modules.

The following service procedures require either a programming or a setup event performed for a complete repair.

scientia non olet · About LEMON Manuals