Setup for Component Replacement
WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
The replacement of some components will require a setup procedure for complete repair.
If any of the following components are replaced, the corresponding procedure must be performed.
Steering Angle Sensor
Calibrate the steering angle sensor. Refer to Steering Angle Sensor Centering .
Multi-Axis Acceleration Sensor
NOTE:
The Multi-axis Acceleration Sensor is also known as the Inertia Sensor Module (IMU) in SPS. The sensor must be configured using SPS before the vehicle yaw sensor learn is performed with the scan tool.
Calibrate the multi-axis acceleration sensor module. Refer to Multi-Axis Acceleration Sensor Module Programming and Setup .
Brake Pressure Modulator Valve Assembly
Calibrate the brake pressure sensor. Refer to Brake Pressure Modulator Valve Pressure Sensor Calibration .