LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Programming And Setup - All Systems) >> Repair Instructions >> Keyless Entry Control Module Programming and Setup >> Keyless Entry Control Module Programming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Keyless Entry Control Module Programming

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.

To program and setup a new replacement keyless entry control module, perform the following procedure:

  1. Install a scan tool with a MDI and access SPS. Refer to Service Programming System (SPS) .
  2. Follow the screen prompts in SPS regarding programming the module.
  3. Check the driver information center display for additional instructions regarding further calibration instructions. If there are no addition driver information center instructions present, programming is complete.

If the keyless entry control module fails to accept the program, perform the following steps:

IMPORTANT: After programming, perform the following to avoid future misdiagnosis:
  1. Turn the ignition OFF for 10 seconds.
  2. Connect the scan tool to the data link connector.
  3. Turn the ignition ON with the engine OFF.
  4. Use the scan tool in order to retrieve history DTCs from all modules.
  5. Clear all history DTCs.
scientia non olet · About LEMON Manuals