Replace and Program EBCM or Reprogram EBCM
WARNING: This page is about a different car, the 2011 Chevrolet Volt. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing EBCM, perform the following procedure:
- Install EL-49642 SPS Programming Support Tool. See Special Tools .
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module-Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module- Setup and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
- With a scan tool access the EBCM, Configuration/Reset Functions, Electronic Brake Control Module Learn.
- With a scan tool, access the EBCM, Configuration/Reset Functions, Brake Control Learn.
- With a scan tool, access the Multi-Axis Acceleration Sensor Module, Configuration/Reset Functions, Yaw Rate Sensor Learn.