Installation Procedure

Fig 1: Locating BCM & Bracket

Courtesy of GENERAL MOTORS COMPANY

Install the BCM (1) into the bracket.
Ensure the BCM (1) is engaged in the bracket, under the retaining tabs (2).

Fig 2: Electrical Connectors And Body Control Module
Courtesy of GENERAL MOTORS COMPANY
Connect the electrical connectors (2) to the BCM (1).

Fig 3: Identifying Right Side Knee Bolster Trim Panel
Courtesy of GENERAL MOTORS COMPANY
Install the right side knee bolster trim panel. Refer to Passenger Knee Bolster Replacement .
If you replaced the BCM, program the module. Refer to Body Control Module Programming and Setup .
Refer to Control Module References for programming and setup information.