Removal Procedure
- Remove the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
- Remove the wire harness assembly (1) from the wire harness strap (2).
- Disconnect the turn signal multifunction switch connector from the inflatable restraint steering wheel module coil connector.
- Slide the 2 connectors (2) of the turn signal multifunction switch assembly out of the bulkhead connector (1).
- Remove the turn signal multifunction switch bolts (1) and (3) from the turn signal multifunction switch (2).
- Remove the turn signal multifunction switch (2) from the steering column tilt head assembly.
NOTE:
The abrasion sleeve located on the steering column wire harness assembly must be reinstalled. Make note of what connector is coming out of the abrasion sleeve for installation purposes.