Replace and Program Electronic Brake Control Module or Reprogram Electronic Brake Control Module
WARNING: This page is about a different car, the 2012 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
To program a replacement or an existing Electronic Brake Control Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module - Setup and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module - Configuration and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select Electronic Brake Control Module - Learn/Setup and follow the on-screen instructions.
- At the end of programming, choose the "Clear All DTCs" function on the SPS screen.
- With a scan tool access the Electronic Brake Control Module, Configuration/Reset Functions, Brake Pressure Sensor Calibration. Refer to Brake Pressure Modulator Valve Pressure Sensor Calibration .
- With a scan tool, access the Electronic Brake Control Module, Configuration/Reset Functions, Steering Wheel Angle Sensor Learn. Refer to Steering Angle Sensor Centering .