LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Sonic RS, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 317 (Programming And Setup - All Systems) >> Repair Instructions >> Electronic Brake Control Module Programming and Setup >> Electronic Brake Control Module Replacement and/or Reprogramming
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Electronic Brake Control Module Replacement and/or Reprogramming

WARNING: This page is about a different car, the 2012 Chevrolet Sonic. However, it is still accessible from the selected car via links, so may be relevant.

If the electronic brake control module (EBCM) needs to be replaced or reprogrammed, the following procedures must be performed:

  1. Place vehicle on a level surface.
  2. Apply the parking brake, or set the transmission in the P position.
  3. Release the brake pedal.
  4. Using the steering wheel, align the front wheels in the straight position.
  5. Install the scan tool to the data link connector.
  6. Ignition ON, engine OFF
  7. Select Vehicle Identification Number (VIN) from the EBCM Configuration/Reset Functions list.
  8. Follow the scan tool directions to complete the programming procedure.
  9. Select Steering Wheel Angle Sensor Learn from the EBCM Configuration/Reset Functions list.
  10. Follow the scan tool directions to complete the programming procedure.
  11. Select Yaw Rate Sensor Learn from the EBCM Configuration/Reset Functions list.
  12. Follow the scan tool directions to complete the programming procedure.
  13. Clear DTCs after completing the programming procedure.
scientia non olet · About LEMON Manuals