LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Chevrolet >> 2013 >> Spark LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 31 (Programming And Setup - All Systems) >> Repair Instructions >> Power Steering Control Module Programming and Setup >> Replace and Program Control Module or Reprogram Control Module
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Replace and Program Control Module or Reprogram Control Module

WARNING: This page is about a different car, the 2014 Chevrolet Spark. However, it is still accessible from the selected car via links, so may be relevant.

This control module does not require SPS programming or any setup procedures.

This control module does not require SPS programming but does require the following setup procedures after a new control module is installed:

To program a replacement or an existing control module, perform the following procedure:

  1. Install EL-49642  SPS Programming Support Tool.
  2. Using the steering wheel, align and center the front wheels forward.
  3. Apply the parking brake, and set the transmission in Park if equipped with an automatic transmission.
  4. Turn ON the ignition, with the engine OFF.
  5. Access the Service Programming System (SPS) and follow the on-screen instructions.
  6. On the SPS Supported Controllers screen, select Power Steering Control Module - Programming and follow the on-screen instructions.
  7. Using a scan tool, select Power Steering Control Module and perform the Configuration/Reset Functions, Steering Wheel Angle Sensor Centering procedure and follow the on-screen instructions.
  8. Clear all DTCs after completing the programming and setup procedures.
  9. Turn OFF the ignition.
scientia non olet · About LEMON Manuals