Keyless Entry Control Module Scan Tool Information

Parameter	Expected Value	Description
Operating Conditions: Ignition ON
Key in Ignition Lock Signal	Active/Inactive	The scan tool displays Active or Inactive. This is the state of the key in ignition switch.
Ignition 1 Signal	RPM	This parameter displays the rotational speed of the engine expressed as revolutions per minute.
Driver Door Key Unlock Switch Signal	Active/Inactive	This parameter indicates if the driver door is locked or unlocked.
Passenger Door Key Unlock Switch Signal	Active/Inactive	This parameter indicates if the passenger door is locked or unlocked.
Door Ajar Switch	Active/Inactive	This parameter indicates that the door is ajar; it is open, but the safety latch is engaged.
Hood Open Switch	Active/Inactive	This parameter indicates that the hood is ajar; it is open, but the safety latch is engaged.
Rear Closure Status	Varies	This switch indicates if the rear closure of the vehicle is ajar.

Keyless Entry Control Module Scan Tool Output Controls

Output Control	Description
Exterior Lamp Flash	This output control is used to turn ON or OFF the exterior lamp depending on this control when the door is unlocked by the key transmitter.